Go To...

drz rotor thickness

Home › Forums › Mud n Tar Suzuki Bikes Forum › Mud n Tar Suzuki Bikes Forum › drz rotor thickness

This topic contains 4 replies, has 0 voices, and was last updated by  Greg 15 years, 6 months ago.

Log In Register Lost Password
Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • September 29, 2009 at 10:21 am #97245

    Mark Murphy
    Member

    I’m doing the rear brakes on the Drz and not sure of the thickness of the brake rotar. If anyone can help out it would be appreciated. One shop I asked said 3mm another said 2.5mm

    September 29, 2009 at 11:48 am #154475

    Greg
    Member

    2.5mm is the minimum spec mate, but just bang some pads in it it will be OK mate

    TB

    September 29, 2009 at 11:53 am #154486

    Anonymous

    Thanks to my mate Boulder, I have the service manual for the 2000 to 2007 DRZ400 and it states that the disc’s should be minimum 2.5mm. It also states and I don’t know what this means is that the brake disc runout limit is .3mm. TB will be able to confirm this but I am thinking that this is the variation in thickness around the disc (?)

    Thanks Boulder!

    September 29, 2009 at 12:04 pm #154488

    Greg
    Member

    KylieD wrote:

    Quote:
    I am thinking that this is the variation in thickness around the disc (?)

    Yes Kylie that’s exactly correct

    TB

    September 29, 2009 at 12:05 pm #154487

    Dean
    Member

    yep min thickness is 2.5mm

    Kylie run out is the distance that a disk runs out of true,in this case max 0.3mm

    Ollie

  • Author
    Posts
Log In Register Lost Password
Viewing 5 posts - 1 through 5 (of 5 total)

You must be logged in to reply to this topic.