This topic contains 5 replies, has 0 voices, and was last updated by 
-
Gyday Guys, I have just fitted a MSC welded type spigot to my Brothers RMX. I was wondering if the machined vertical spigot is also to be welded to the bracket. It is a machined fit and has little movement side to side where the load will be applied but front to back the spigot can be dislodged. Has anyone had any experience with these welded type spigots?
cheers
Ollie
huzza147 wrote:
Quote:I always have, and never had a problem. The thing wouldn’t stay there long otherwise. Preferable to be done neatly with a TIG, not like the cocky-shit on the base.Ease up Huzza
That spigot is going nowhere, low Hydrogen rods were used and I did two runs. Still has to be cleaned up with a flap disk:laugh: I think I will put a couple of Tacks onto the spigot just to be sure. Havent got accessto a TIG at my Bro’s place in Maitlan:(cheers Ollie
Mine is tacked, its MSC
That weld in shocking Ollie it looks shocking, better make sure that flapper wheel is attached to a 9 inch grinder and a front rower to lean on it :laugh:
TB
Trailboss wrote:
Quote:Mine is tacked, its MSC
That weld in shocking Ollie it looks shocking, better make sure that flapper wheel is attached to a 9 inch grinder and a front rower to lean on it :laugh:
TB
isnt yours alloy?
The rods were only 2MM jobs and I had a Jack Daniels induced weave happening:laugh: Guarantee its not gonna move;)
Ollie
Ollie wrote:
Quote:Trailboss wrote:Quote:Mine is tacked, its MSC
That weld in shocking Ollie it looks shocking, better make sure that flapper wheel is attached to a 9 inch grinder and a front rower to lean on it :laugh:
TB
isnt yours alloy?
The rods were only 2MM jobs and I had a Jack Daniels induced weave happening:laugh: Guarantee its not gonna move;)
Ollie
Of course it is :laugh: nice excuse for the crappy weld
TB
You must be logged in to reply to this topic.