Opinions on this run in method!!

[Gareth Morgan-ThomasMember]

Copied from Mototune website!

Here’s How To Break-In An Engine Properly:

Then, using 4th gear:

Do Three 1/2 Throttle dyno runs from
40% – 60% of your engine’s max rpm
Let it Cool Down For About 15 Minutes

Do Three 3/4 Throttle dyno runs from
40% – 80% of your engine’s max rpm
Let it Cool Down For About 15 Minutes

Do Three Full Throttle dyno runs from
30% – 100% of your engine’s max rpm
Let it Cool Down For About 15 Minutes
Go For It !!

So what do you think? TB, youv’e had a bit to do with engines!!

[GregMember]

Umm if it was mine I would take it for a 15 min half throttle ride. Let I cool for a couple of hrs, same again. Change the oil and filter, fill it with Motul 5100 and ride it like I stole it. ALWAYS WARM IT UP BEFORE GETTING UP IT, ALWAYS

IMO

TB

[Gareth Morgan-ThomasMember]

Yeah, thats always been mine too but an interesting read non the less!

[GregMember]

1inarow wrote:

Yeah, thats always been mine too but an interesting read non the less!

It’s not bad if you have a dyno maybe :laugh:

Hey you still selling tyres ? Need a set soon for company car (Hilux) will come out for them I have a couple of customers I need ro see

TB

[Gareth Morgan-ThomasMember]

Sure are! Is it fleet managed or ……

[GregMember]

Lease plan

[Gareth Morgan-ThomasMember]

No problem with Lease Plan. If it’s an SR5 with the 15″ wheels then Goodyear Dunlop make a 255/70-15 tyre to suit but out of stock until 1st week of April! All other sizes are covered!

Just confirm the size and give me a couple of days notice and floods aside… all will be good! In and out in 2 hr’s with alignment!

6331 2600 wk

[GregMember]

Its an SR5 yes. Will be in touch its done 40 odd thousand and the standard ones a scarey fun in the wet eh Deejay :laugh:

TB

[Gareth Morgan-ThomasMember]

OK, 40ish is about then end eh! Let me know!!

[Author]

Posts