Go To...

Radiator Guards/Braces Fitted

Home › Forums › Kawasaki Bikes › Kawasaki Bikes › Radiator Guards/Braces Fitted

This topic contains 2 replies, has 0 voices, and was last updated by  Chris 16 years, 8 months ago.

Log In Register Lost Password
Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • August 11, 2008 at 1:24 pm #95005

    Chris
    Member

    Hi All,

    Put some Unabiker radiator guards on the KLX, not an overly hard task, no draining of coolant or removing hoses etc, the only issue I had was some of the bolts that shipped with the guards were too long, some of the ones that were 25mm I had to swap for 20mm bolts, especially the ones that go into the tank, I felt if I tightened them any further I was going to put a hole through the tank.. Anyway a couple of pics below..

    Cheers
    Chris.

    S6301037.jpg
    S6301038.jpg
    S6301039.jpg
    S6301040.jpg

    August 12, 2008 at 12:49 pm #106948

    David
    Member

    Nice Job Mate

    August 17, 2008 at 1:18 pm #106978

    Chris
    Member

    Thanks KTM, just in case anyone else stumbles on this, the rear of the front guard now rubs on the clutch cable, I have found by adding a couple of washers under the bolts it will pull it away so it no longer rubs.

    Cheers
    Chris.

  • Author
    Posts
Log In Register Lost Password
Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.